Owner's Manual

2-19
Hardware Setup
CF Mode Selecting Jumper: JCF_SEL
This jumper is used to select Master/Slave mode of the CF device.
PCI-X Jumper: J5
This jumper controls the operation frequency of the onboard PCI-X slot. Short con-
nect pin#1-2 will force the PCI-X to run at 133MHz.
133MHz
1
1
J5
100MHz
1
CF Voltage Selecting Jumper: JCFV_SEL
This jumper is used to select the operating voltage of the CF device.
JCF_SEL
1
Slave
1
3
Master
1
3
JCFV_SEL
1
VCC5
1
3
VCC3
1
3
9188v1.0-2.p65 2009/2/11, 下午 04:5019
PDF created with pdfFactory Pro trial version www.pdffactory.com