User Manual

M S D I G N I T I O N • w w w. m sd ig ni ti on .c om • ( 91 5) 8 5 7- 52 00 • F A X (9 15 ) 85 7- 33 4 4

MSD-to-Dodge Harness

1998-2003, PN 8884/1990-1997, PN 8889

Figure 1 Dodge Coil.

Figure 2 Installation with an MSD 6 or 7 Series Ignition Control.

PN 8884/PN 8889

FACTORY DODGE HARNESS

(UNPLUGGED FROM COIL)

IMPORTANT: Review the Ignition Control Instructions before attempting the installation.

The MSD-to-Dodge Coil Harness is designed to provide a splice-

free and simple installation of an MSD Ignition Control to late model

Dodge vehicles equipped with the coil shown in Figure 1.

MSD 6 and 7 Series Ignitions

All of the wires connect to the corresponding colored wires (Figure

2). MSD 7 Series Ignitions share the same color wires.

1. Disconnect the connector from the coil and connect it to the

MSD PN 8884/PN 8889 Harness.

2. Connect the other end of the Harness to the Coil.

3. Connect the four wires of the Harness to the MSD Ignition

Control.

Parts Included:

1 - MSD Harness

PAGE 1
MSD-to-Dodge Harness 1998-2003, PN 8884/1990-1997, PN 8889 Parts Included: 1 - MSD Harness IMPORTANT: Review the Ignition Control Instructions before attempting the installation. The MSD-to-Dodge Coil Harness is designed to provide a splicefree and simple installation of an MSD Ignition Control to late model Dodge vehicles equipped with the coil shown in Figure 1. MSD 6 and 7 Series Ignitions All of the wires connect to the corresponding colored wires (Figure 2).
PAGE 2
Installation with an MSD Timing Control The PN 8884/PN 8889 may still be used when adding an MSD Timing FACTORY DODGE HARNESS (UNPLUGGED FROM COIL) Control. Figure 3 shows a common installation. Figure 3 Wiring in an MSD Timing Control with a 6 or 7 Series Ignition. MSD 5 and Blaster Ignition Note that the MSD 5 and Blaster Ignitions wire differently than the 6 and 7 Series Ignitions. The Red wire of the MSD 5 or Blaster Ignition connects to both the Harness Orange and Red wires (Figure 4).