Installation Owner manual

INSTALLATION INSTRUCTIONS 5
M S D I G N I T I O N • w w w . m s d i g n i t i o n . c o m • (9 1 5 ) 8 5 7 - 5 2 0 0 • F A X (9 1 5 ) 8 5 7 - 3 3 4 4
1. Remove the existing distributor cap without
disconnecting any of the spark plug wires.
2. With the cap off, crank the engine until the
rotor is aimed at a fixed point on the engine or
firewall. Note this position by making a mark
(Figure 8).
3. Place the distributor cap back on and
note which plug wire the rotor is pointing
to. MARK THE SPARK PLUG WIRES and
remove the distributor cap.
4. D i s c o n n e c t t h e w i r i n g f r o m t h e
distributor.
5. Loosen the distributor hold down clamp
and slide the clamp out of the way.
6. Lift the distributor out of the engine. Note
that the rotor rotates as you lift the distributor
out. This is due to the helical cut gear and
should be taken into consideration when
installing the new distributor.
7. Install the gasket and apply a liberal
amount of the supplied lubricant to the
distributor gear (The supplied O-rings
can only be used if the block has been
modified as shown in Figure 9).
8. Install the distributor making sure that the
rotor comes to rest pointing at the fixed mark.
If the distributor will not fully seat with the rotor
pointing to the marked position, you may
need to rotate the oil pump shaft until the rotor
lines up and the distributor fully seats.
9. Position and tighten the hold down clamp
onto the distributor.
10. Install the distributor cap and spark plug wires
one at a time to ensure correct location. A
wire retainer is supplied to secure the wires
in place. Align the mounting bosses and use
the supplied 1.5" self-tapping Phillips screws
to hold the retainer in place.
Figure 8 Marking the Rotor Location.
INSTALLING THE DISTRIBUTOR
Figure 9 Modified Block for use with O-Rings.
Figure 10 Optional Installation by Bolting Cap Down.
Installation Option: This Cap can also be
bolted down to an MSD Pro-Billet or Billet
Distributor base with the supplied hardware.
To accomplish this, the spring clips must be
cut off (Figure 10).
Note: When the cap is bolted down, the
location of the spark plug wires must
be changed.
Note: Block must be modified to use O-Rings.