Manualshelf

Installation Instruction Manual

ManualsBrandsMSD ManualsCar8362 Street Fire Chevrolet V8 GM HEI Distributor
12
Important:  Read these instructions before attempting the installation.
Parts Included:
  1 - Distributor
  1 - Gasket
  1 - Tube of Gear Lubricant
  1 - Vacuum Advance Stop Plate, PN 84281
WARNING: Before installing the Distributor, disconnect the battery cables. When disconnect-
ing the battery cables, always remove the Negative (-) cable first and install it last.
Replacement Parts:
  1 - Rotor, PN 8410
  1 - Cap, PN 8411
  1 - Coil Cover, PN 8402
1.  Remove the existing distributor cap without disconnecting any 
of  the spark plug wires.
2.  With the cap off, crank the engine until the rotor is aimed at a 
fixed point on the engine or firewall. Note this position by making 
a mark (Figure 1).
3.  Place the distributor cap back on and note which plug wire the 
rotor is pointing to. MARK THE SPARK PLUG WIRES and remove 
the distributor cap.
4.  Disconnect the wiring from the distributor.
5.  Loosen the distributor hold down clamp and slide the clamp out 
of the way.  
6.  Lift the distributor out of the engine.  Note that the rotor rotates 
as you lift the distributor out. This is  due to the helical cut gear 
and should be taken into consideration when installing the new 
distributor.
7.  Install the gasket and apply a liberal amount of 
the supplied lubricant to the distributor gear. 
8.  Install the distributor making  sure that the rotor 
comes to rest pointing at the same fixed mark. 
If the distributor will not fully seat with  the rotor 
pointing to the  marked position, you may need 
to rotate the oil pump shaft until the rotor lines up 
and the distributor fully seats. 
9.  Position and tighten the hold down clamp onto 
the distributor.  
10. Install the distributor cap and spark plug wires one 
at a time to ensure correct location.
11.  Connect a switched 14-gauge wire from a 12 volt 
source to the B+ terminal of the Distributor Cap 
(Figure 2). (Be sure the 3-pin connector from the 
module is connected to the cap).
12.  To connect a tachometer, plug the trigger wire of 
the tach to the "tach" terminal of the cap.
Figure 1 Marking the Rotor Location.
Figure 2 General Wire Installation.
Street Fire HEI Distributor, Chevy V8
PN 8362
S T R E E T F I R E • W W W . S T R E E T - F I R E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.

Summary of content (2 pages)