Owners manual

INSTALLATION INSTRUCTIONS 7
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]
TIPS & TROUBLESHOOTING:
No spark after Tester is connected:
• Inspect the wiring of the tester. Make sure you have a good ground and 12 volt source.
• Check to make sure you have the correct testing program for your application.
• Swap another coil in and repeat the test. If spark occurs, the coil is at fault.
Figure 11 Testing a Dual Coil MSD 10 Ignition.
NOTE: THE DUAL COIL MSD 10 HAS BEEN REPLACED
BY THE MSD 10-PLUS IGNITION.