Owners manual

Retard Degree Module Selector Switch
PN 8676 0° - 11°
PN 8678 0°/10° - 20°
Parts Included:
1 – Retard Degree Module Selector Switch
4 – Mounting Screws
Mount the Switch close to the MSD Ignition in a position so it is accessible and easy to read. The
wires of the Switch cannot be lengthened. Use the supplied mounting screws or the adhesive on
the back panel of the unit to mount the Switch.
The 2-pin connector of the Switch plugs into the retard degree module receptacle of the MSD
component. There is no polarity so its position does not make a difference.
Figure 1 Retard Degree Module Selector Installation.
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]