Owners manual

6
INSTALLATION INSTRUCTIONS
MSD •  WWW.MSDPERFORMANCE.COM •  (915)  855-7123  •  FAX  (915)  857-3344
PRESTART CHECK LIST
The only wires connected to the coil terminals are the MSD Orange to coil positive and Black to
coil negative.
The small Red wire of the MSD is connected to a switched 12 volt source.
The MSD power leads are connected directly to the battery positive and negative terminals.
The battery is connected and fully charged if not using an alternator.
The engine is equipped with at least one ground strap to the chassis.
If you are installing on a 4 or 6-cylinder engine, conrm the programming loops have been modied,
see page 5.
THEFT DETERRENT
The MSD provides the opportunity to easily install a theft deterrent kill switch (Figure 3).
White Wire Trigger
When using the WHITE wire to trigger the MSD, install a switch across the magnetic pickup VIOLET wire
to ground. When the VIOLET wire is grounded, the vehicle will crank but not start.
Magnetic Pickup Trigger
When using the mag pickup to trigger the MSD, install a switch to the WHITE wire and the other side to
ground. When the WHITE wire is grounded, the vehicle will crank but will not start.
TROUBLESHOOTING
Every MSD Ignition undergoes numerous quality control checks including a four hour burn-in test. If you
experience a problem with your MSD, our research has shown that the majority of problems are due to
improper installation or poor connections.
The Troubleshooting section has several checks and tests you can perform to ensure proper installation
and operation of the MSD. If you have any questions concerning your MSD, call our Customer Support
Department at (915) 855-7123, 7 - 5 mountain time.
LED
The LED will flash for every trigger signal from the distributor or crank trigger. You can take advantage
of this when statically setting the timing when false triggering the box to troubleshoot. Also, when the
engine is not running, the LED will be On when the key is in the On position.
Figure 3 Connecting a Theft Deterrent Switch Through the MSD Ignition.