Owners manual

12 INSTALLATION INSTRUCTIONS
The following wiring diagrams illustrate numerous installations on different vehicles and applications. If
you experience difficulties when installing your MSD, contact our Customer Support Department at (915)
855-7123 (7 - 5 Mountain time) or e-mail us at: [e-mail]
Figure 12 Crimping a Dual Crimp Terminal.
CRIMPING
If you need to change your coil wire to match the
terminal of the Blaster SS, you will need to carefully
strip your wire and follow the steps to properly
crimp the MSD Dual Crimp Terminal (Figure 12).
1. Carefully strip about 3/8” of your coil wire’s
sleeve. Use extreme care not to touch the
conductor.
2. Crimp the spark plug wire into the large tabs
using needlenose pliers. Do not over-crimp or
cause the sleeve to tear.
3. Position the conductor between the smaller crimp
tabs then crimp the tabs over the conductor
using the needlenose pliers. It is recommended
to check the resistance of the finished wire to
confirm that the wire crimp is in good condition.
Limited Warranty
M SD warrants this product to be free from defects in material and workmanship under its intended normal use*,
when properly installed and purchased from an authorized MSD dealer, for a period of one year from the date of
the original purchase. This warranty is void for any products purchased through auction websites. If found to be
defective as mentioned above, it will be repaired or replaced at the option of MSD. Any item that is covered under
this warranty will be returned free of charge using Ground shipping methods.
This shall constitute the sole remedy of the purchaser and the sole liability of MSD. To the extent permitted by
law, the foregoing is exclusive and in lieu of all other warranties or representation whether expressed or implied,
including any implied warranty of merchantability or fitness. In no event shall MSD or its suppliers be liable for special
or consequential damages.
*Intended normal use means that this item is being used as was originally intended and for the original application
as sold by MSD. Any modifications to this item or if it is used on an application other than what MSD markets the
product, the warranty will be void. It is the sole responsibility of the customer to determine that this item will work for
the application they are intending. MSD will accept no liability for custom applications.
Service
In case of malfunction, this MSD component will be repaired free of charge according to the terms of the warranty.
When returning MSD components for warranty service, Proof of Purchase must be supplied for verification. After
the warranty period has expired, repair service is based on a minimum and maximum fee.
All returns must have a Return Material Authorization (RMA) number issued to them before
being returned. To obtain an RMA number please contact MSD Customer Service at 1 (888) MSD-7859 or visit
our website at www.msdperformance.com/rma to automatically obtain a number and shipping information.
When returning the unit for repair, leave all wires at the length in which you have them installed. Be sure to include
a detailed account of any problems experienced, and what components and accessories are installed on the vehicle.
The repaired unit will be returned as soon as possible using Ground shipping methods (ground shipping is covered
by warranty). For more information, call MSD at [phone]. MSD technicians are available from 7:00 a.m. to
5:00 p.m. Monday - Friday (mountain time).
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]
© 2013 MSD LLC
FRM30505 Revised 12/13 Printed in U.S.A.