Owners manual

WARNING: Disconnect the battery during installation. When disconnecting the battery, always
remove the negative cable rst and install it last.
Figure 2 Washer Installation.
MSD Rotor, PN 8467
Fits MSD Distributors with Caps PN 8433,
PN 8431 and other GM Window Style Caps
Parts Included:
1 – Rotor, PN 8467
2 – 5/8” Phillips Head Screws
IMPORTANT: There are two different length screws supplied with this rotor. It is important to determine
which screws are correct for your application due to clearance of the magnetic pickup.
Remove the cap and rotor and note the rotor screw retainer that is installed on the bottom of the
advance plate (Figure 1). There are two styles used; one is a Screw Retainer, the other is a Retainer
with a Nut. The Retainer accepts the shorter 5/8” screw while the Nut version accepts the 3/4” screw.
Once the rotor screw length is determined, install the rotor being
sure the round and square aligning pegs are lined up correctly.
Install the Belleville washers with the dome facing up on the
screws and tighten the rotor (Figure 2). Install the cap and plug
wires.
Figure 1 Determining Rotor Screw Length.
Note: It is recommended to install the rotor and check the
clearance before reassembling the distributor.
ROTOR SCREW
RETAINER
ROTOR SCREW
RETAINING NUT
USE 5/8"
SCREW
USE 3/4"
SCREW
2 – 3/4” Phillips Head Screws
2 – Belleville Washers
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.