Owners manual

Billet Hold Down Clamp, Ford

PN 8010

Parts Included

1 - Billet Clamp

1 - 5/16" - 18 x 1.75" set screw

1 - 5/16" - 18 nut

1 - 5/16" Lock Washer

1 - 5/16" Flat Washer

INSTALLATION

1. Install the set screw into the block using

a 5/32" Allen wrench.

2. Install the Billet Clamp, ﬂat washer, lock

washer and the nut on the set screw.

3. With the housing in the correct timing

position, tighten the nut. Figure 1 shows

the correct installation of the clamp. If

the clamp is excessively angled and

the end points of the clamp do not

properly seat, the clamp will not tighten

properly.

Figure 1 Billet Hold Down Clamp Installation.

Limited Warranty

SD IGNITION warrants this product to be free from defects in material and workmanship under its intended normal

use*, when properly installed and purchased from an authorized MSD dealer, for a period of one year from the date

of the original purchase. This warranty is void for any products purchased through auction websites. If found to be

defective as mentioned above, it will be repaired or replaced at the option of MSD Ignition. Any item that is covered

under this warranty will be returned free of charge using Ground shipping methods.

This shall constitute the sole remedy of the purchaser and the sole liability of MSD Ignition. To the extent permitted

by law, the foregoing is exclusive and in lieu of all other warranties or representation whether expressed or implied,

including any implied warranty of merchantability or ﬁtness. In no event shall MSD Ignition or its suppliers be liable

for special or consequential damages.

*Intended normal use means that this item is being used as was originally intended and for the original application

as sold by MSD Ignition. Any modiﬁcations to this item or if it is used on an application other than what MSD Ignition

markets the product, the warranty will be void. It is the sole responsibility of the customer to determine that this item

will work for the application they are intending. MSD Ignition will accept no liability for custom applications.

M S D I G N I T I O N • w ww .m sd ig n it io n. co m • ( 91 5) 8 5 7 - 52 00 • F AX ( 91 5 ) 85 7- 33 44

FRM28594 Revised 05/07 Printed in U.S.A.