Owners manual

INSTALLATION INSTRUCTIONS 3
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]
Figure 2 Power Module Harness
MOUNTING
The Power Module must be mounted in a sturdy, dry location and away from extreme heat. The Power
Module should be mounted using the included rubber mounts to limit excessive vibration. The unit
is fully potted, but should not be immersed or subjected to direct spray from a power washer.
MSDVIEW
The MSDView software allows editing of the Output Settings, Timing and Data Acquisition tabs, as
well as turning features on/off and setting up and retrieving data logs.
The following information provides a brief explanation of each function or feature.
While using the software, you can mouse over each item for a brief on-screen explanation. When the
system controller is con nected to a PC via USB, MSDView will automatically recognize it and load
the settings stored in the Power Grid Power Module.
INSTALLATION OF THE MSDVIEW SOFTWARE
1. Insert the installation CD Rom into the DVD/CD drive, wait up to 30 seconds, the CD will autorun,
IF THIS DOES NOT OCCUR:
Locate and open the DVD/CD Drive.
Double click on the Setup le - “autorun.exe”
2. Select “Install MSD View Software” button.
3. Click “Next” in the ‘Setup - MSD View’ window.
4. Accept the agreement on the ‘Setup MSD View window’ & keep the ‘Create a desktop icon’
check-box checked. Click ‘Next’.
5. Click ‘Install’ to begin MSD View installation, then click ‘Finish’
6. MSD View product list box will open showing connected products to choose from (if any).
7. If no product is seen, connect your MSD device to your PC via a USB cable. It should appear in
a few seconds.
8. Click the check box then the ‘View’ button or double click on the product line.
9. The MSD software will open showing the products software interface.
Note: The MSDView Software can be downloaded from www.msdperformance.com.