Owners manual

2 INSTALLATION INSTRUCTIONS
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]
WIRING
Figure 2
Recieves 12V switched from Power
Grid Controller. Also communicates
between modules and Power Grid
System Controller. This connector
is only used with modules added
onto the system.
These wires switch to a low current
ground when activated. Should be
used in conjunction with a relay.
Figure 1
OPERATION
To program the 3-Stage Delay Timer module start MSD View and connect to the 7760 with the ignition
on.
• Turn on ignition power
• Connect 7730 to PC via USB
• Start MSD View
• In the Connect box select 7760
• Click “Connect”
MSD View will display three tabs 1, 2, 3. Each tab corresponds to each output wire.
RED LED
The LED indicates that the module is communicating with MSD View.
Without a connection to a PC or Laptop the LED will be "Off".
OUTPUT SWITCH 1, 2, 3:
RPM Switch: There are two settings for this function Enabled/ Disabled. Default value is Disabled. To
activate the RPM ON/OFF function change the value to Enabled.
RPM ON/RPM OFF: These settings can range from 0-15000RPM.
If the RPM ON setting is
set below the RPM OFF
setting, the RPM Switch
functions as a window
switch, and will activate
the output wire when
RPM increases above
the RPM ON setting.
The output wire will
deactivate once the RPM
increases above the OFF
setting (Figure 2).
Leading Group Wire Color Function Description
6-Pin CONN RED 22ga. MSD CAN HI
BROWN 22ga. SHIELD
RED 18ga. POWER
BLACK 22ga. MSD CAN LO
BLACK 22ga. MSD CAN GND
Loose Wires BROWN STAGE 1
ORANGE STAGE 2
WHITE STAGE 3