Owners manual

Street Fire HEI Module
PN 5596
WARNING: Before installing the Module, disconnect the
battery cables. When disconnecting the battery
cables, always remove the Negative (-) cable
first and install it last.
STREET FIRE • WWW.STREET-FIRE.COM • [phone] • FAX [phone]
1. Disconnect the wiring from the distributor cap.
2. Remove the distributor cap without disconnecting any of the
spark plug wires.
3. Remove the rotor.
4. Disconnect the wiring from the Module.
5. Remove the two screws and lift the Module out.
6. Apply a liberal amount of heat sink to the new Module and
position it in the housing and install the retaining screws.
7. Reinstall the connectors, rotor and cap.
Figure 1 Replacing the Module.
Important: Read these instructions before attempting the installation.
Parts Included:
1 - Module
HEI MODULE
1 - Heat Sink Compound
Street Fire HEI Module
PN 5596
WARNING: Before installing the Module, disconnect the
battery cables. When disconnecting the battery
cables, always remove the Negative (-) cable
first and install it last.
STREET FIRE • WWW.STREET-FIRE.COM • [phone] • FAX [phone]
1. Disconnect the wiring from the distributor cap.
2. Remove the distributor cap without disconnecting any of the
spark plug wires.
3. Remove the rotor.
4. Disconnect the wiring from the Module.
5. Remove the two screws and lift the Module out.
6. Apply a liberal amount of heat sink to the new Module and
position it in the housing and install the retaining screws.
7. Reinstall the connectors, rotor and cap.
Figure 1 Replacing the Module.
Important: Read these instructions before attempting the installation.
Parts Included:
1 - Module
HEI MODULE
1 - Heat Sink Compound