Owners manual

INST A LLATI O N INS T RUCTI O NS 3
MSD POWERSPORTS • WWW.MSDPOWERSPORTS.COM • [phone] • FAX [phone]
CONNECTING THE HOLESHOT/OVERTEMP RPM LIMITER
The PINK Wire of the Enhancer Ignition is for the Holeshot/Overtemp feature. There are several options
in the way this feature can be used.
The Holeshot feature of the Enhancer Ignition is designed for use at the starting line. When activated,
the Holeshot feature limits the engine rpm at approximately 3,200 - 3,600 rpm with the throttle fully
open. This feature provides more consistent holeshots. To use the Holeshot feature, you will need
the Holeshot Switch (PN 4372). The Overtemp feature limits the engine rpm to approximately 3,600
rpm if the engine reaches a damaging temperature.
HOLESHOT FEATURE ONLY
This installation provides you with the Holeshot feature only.
1. Connect one side of the Holeshot Switch (PN 4372, not supplied) to the PINK wire of the Enhancer.
Connect the other wire of the Holeshot Switch to ground (Figure 3).
HOLESHOT/ENGINE OVERTEMP FEATURE
This installation provides you with the Overtemp feature only. Refer to Figure 1 for wiring.
1. Connect the PINK wire of the Enhancer to the PINK wire of the factory temperature sensor.
2. Splice one side of the Holeshot Switch (PN 4372, not included) into the PINK wire of the Enhancer.
Connect the other wire of the Holeshot Switch to ground (Figure 3).
Figure 2 The Adjustable RPM Potentiometer.
3. Once you have the desired rpm limit set, tighten the
locknut on the potentiometer. Hold the shaft in place with
a screwdriver as you tighten the nut to prevent the rpm
limit from changing.