Owners manual

Pro-Boot Guard
Pro-Heat Guard
PN 3411
Slide this sleeve over the wire to
guard against heat and abrasion.
Roll of 25 feet.
Dual Plug Separators
Molded of strong, heat resistant
material, these handy separators will hold
two wires secure.
Sold in a pack of 16.
8mm and 8.5mm, PN 8841
Wires w/sleeve, PN 8842
Spark Guard
PN 8804
The di e l e c t r i c gr e a s e
eases crimping and boot
i n s t a l l a t i o n , p r e ve n t s
moisture buildup inside the
boots and helps stop voltage
leaks. Spark Guard will not
dry up or harden.
Shrink Sleeve
PN 3407
This sleeve will seal the Pro-Heat Sleeve
to the plug wire or boot. It will not split and
is designed to withstand high underhood
temperatures.
PN 8843
The best wire separators available! The
wires are clamped into place and no
tools are required to open the clamps.
Supplied with; 2-four wires,
4-three wires, 4-two wires.
Pro-Clamp Separators
PN 3412
Thick woven glass and
silicone will protect the
boots. Roll of six feet.
Cylinder Number
Indicators
Marking the cylinder number
of each plug wire can save you
time and ensure that the wire is
installed in the right place.
Cylinder Markers, PN 3414
Shrink Sleeve Cylinder Numbers, PN 3415
Pro-Crimp Tool
PN 35051
A hardened steel frame sports comfortable molded hand grips
while a slick ratchet action provides secure factory style crimps
consistently. The Tool is supplied with crimp/strip jaws for MSD’s
8.5mm Dual Crimp Terminals only. It also accepts interchangeable
jaws allowing for a variety of different style crimps.
Replacement Dies
Pro-Crimp Jaws for use with the Pro-Crimp Tool only.
Amp Pin Terminal, PN 3506
Amp Lug Terminal, PN 3507
Plug Wire Terminal, PN 3508
Weathertight Connector Terminal, PN 3509
Deutsch Connector Terminal, PN 3510
PN 3506 PN 3507 PN 3509PN 3508
FRM 29739