Specifications

HDC-1801 HD Downconverter & DA with Analog Monitoring Output
Guide to Installation and Operation
Page 16 of 17 HDC-1801
User Presets
The User Presets are a set of five registers, each of
which can store a complete set of parameter
settings.
The User preset registers are accessed from the
User Presets controls at the bottom left of the
control panel.
Select any one of the five presets using the
pulldown list. The name of the currently-selected
User Preset is shown on the on the pulldown icon
(e.g. User1, User2,… User5)
Click Load to load the contents of the selected User
Preset into the HDC-1801. All parameter settings
and values will be replaced by the contents of the
selected User Preset.
Click Save to store the current parameter settings
and values from the HDC-1801 into the selected
User Preset. The existing contents of the preset will
be overwritten.
Error/Warning Configuration
In iControl Navigator, right-click on the HDC-1801
icon, and select the Error/Warning Configuration
option from the pop-up menu. The Log Config panel
opens.
For each of the nine Conditions shown in the panel,
select:
Detection: the checkbox to the immediate right of the
condition name enables detection of the condition. If
it is unchecked, the other options are disabled and
grayed-out in this panel
Condition LEVEL: From the pulldown box, assign a
level of severity to this condition. The choices are:
• YELLOW = warning
• RED = error
Report GUI: a check in this box enables an error
report from this card on the Densité frame’s GUI
output.