Specifications

HDC-1801 HD Downconverter & DA with Analog Monitoring Output
Guide to Installation and Operation
HDC-1801 Page 13 of 17
Input Error
The current ARC status is shown in the two preview
windows at the top of the panel. Click on the ARC
(Aspect Ratio) option to make changes.
Input Error
Select the behavior of the SDI output in the event of
an error in the input signal.
• If the KILL radio button is selected, the SDI output
will be disconnected in case of an input error. The
connector will carry no signal.
• If the BLACK button is selected, the SDI output
connector will carry a signal with BLACK in the
active picture area.
Test
The current ARC status is shown in the two preview
windows at the top of the panel. Click on the ARC
(Aspect Ratio) option to make changes.
Video
Click on the Color Bars (75%) checkbox to place a
75% color bar signal on the video output.
Audio
Click on the Tone checkbox to place audio test tones
on the audio outputs (if the Audio option has been
enabled).
The test tone is a 1 KHz sine wave:
• left channel – pulsed 3 seconds ON, 250 ms OFF
• right channel – steady tone
The test tone will be placed on the AES and
embedded outputs. The input groups that were not
disembedded are blanked.