Technical data
MSA AUER
MSA
Use
EVOLUTION 6000 Thermal Imaging Camera
13
US
3Use
3.1 Safety Instructions
Check the batteries before and during use
Check wh
ether the batteries are fully charged before using. If not fully charged, the nominal oper-
ating time cannot be achieved. Also check the battery level during use.
For details on chargingchapter 3.11.
3.2 Switching ON and OFF
Switching ON in normal mode, function test
Fig. 2 ON/OFF button
(1) Press green ON/OFF button for approx. 1 second.
Within 5 seconds, the TIC carries out a self-test of the sensor electronics.
Status LEDs under display illuminate according to battery status ( section Battery Sta-
tus Indicator page 18).
The current software version briefly displays.
An image appears after a few seconds on the display.
(2) Check camera function:
Direct the camera toward an object or person until the thermal image shows on the dis-
play.
The camera is now ready for use.
Switching OFF
(1) Keep ON/OFF button pressed for approx. 3 seconds until all LED indicators switch off.
(2) Release the ON/OFF button as soon as all LED indicators switch off.
The camera is switched OFF.