Install Manual

mrcool.com

Page 26

Unit Installation

Fig. 2.24

Location of

Dip Switch on

Condenser

Main Board

DEFAULT 3 TON

2 TON SETTING

Fig. 2.23

Fig. 2.25

Follow these instructions during unit installation in order to enable a Universal

Series 3-ton condenser and

air handler split system to operate at 2-ton capacity.

DO NOT attempt this conversion while the unit is powered on.

1. Locate the capacity dip switch on the condenser main board. The capacity dip switch is circled on the

photo below.

2. The default position of the capacity dip switch is 1 & 2 ‘Up’ and 3 & 4 ‘Down’. Up being a switch pushed

toward the letters (ON DIP). Down being a switch pushed toward the numbers (1 2 3 4).

3. The default position of the capacity dip switch is 36K.

4. To activate the 24K capacity, ﬂip capacity dip switch 1 from the Up position to the Down position.

Converting Unit From 3-Ton to 2-Ton

NOTE

Refer to the Universal

Air Handler Installation Manual for Dip Switch Instructions and settings to

convert the Universal

Air Handler from 3-ton to 2-ton, or 5-ton to 4-ton.

Converting Unit From 5-Ton to 4-Ton

Follow these instructions during unit installation in order to enable a Universal

Series 5-ton condenser and

air handler split system to operate at 4-ton capacity.

Fig. 2.26

DEFAULT 5 TON

4 TON SETTING

Fig. 2.27

DO NOT attempt this conversion while the unit is powered on.

1. Locate the capacity dip switch on the condenser main board. The capacity dip switch is circled on

the photo below.

2. The default position of the capacity dip switch is 1 & 2 ‘Up’ and 3 & 4 ‘Down’. Up being a switch

pushed toward the letters (ON DIP). Down being a switch pushed toward the numbers (1 2 3 4).

3. The default position of the capacity dip switch is 60K.

4. To activate the 48K capacity, ﬂip capacity dip switch 1 from the Up position to the Down position.

Condenser Field Conversion