Wired Control Install

3. INSTALLATION METHOD

Fig 3-4

Connect the female joint of wires group from the mainboard with the male joint of

connective wires group. (See Fig.3-3)

Please connect the other side of connective wires group with the male joint of

wires group leads from wire controller. (See Fig.3-3)

Fig 3-3

Indoor display board

5-core wire

3.Wiring figure

4.Remove the upper part of wire controller

The connective wires group

5-core or 4-core wire

Insert a slot screwdriver into the slots in the lower

part of the wire controller (2 places), and remove

the upper part of the wire controller. (Fig.3-4)

Slots

NOTICE

The PCB is mounted in the upper part of the wire

controller. Be careful not to damage the board

with the slot screwdriver.

For more info visit www.mrcool.com