Use and Care Manual
Table Of Contents
- Foreword
 - Safety Notice
 - CONTENTS
 - Safety Notice on Maintenance
 - Safety Notice on Operation
 - 1 Product Introduction
 - NOTE: 1 Ton =12000Btu/h = 3.517kW 1.2 Electrical Parameters
 - 2 Control
 - 3 Troubleshooting
- 3.1 Wiring Diagrams
 - 3.2 PCB Layout
 - 3.3 Error Code
 - 3.4 Troubleshooting
- 3.4.1 “E1” Compressor High Pressure Protection
 - 3.4.2 “E3” Compressor Low-pressure Protection, Refrigerant Shortage Protection, Refrigerant Recovery Mode
 - 3.4.3 “E4” Compressor Air Discharge High-temperature Protection
 - 3.4.4 “F2” Condenser Temperature Sensor Error
 - 3.4.5 “F3” Outdoor Ambient Temperature Sensor Error
 - 3.4.6 “F4” Discharge Temperature Sensor Error
 - 3.4.7 “F6” ODU Tube Temperature Sensor Error
 - 3.4.8“EE” ODU Memory Chip Error
 - 3.4.9 “H4” Overload
 - 3.4.10 “H5” IPM Protection
 - 3.4.11 “H6” DC Fan Error
 - 3.4.12 “H7” Driver Out-of-Step Protection
 - 3.4.13 “HC” PFC Protection
 - 3.4.14 “Lc” Startup Failure
 - 3.4.15 “P0” Driver Reset Protection
 - 3.4.16 “P5” Over-Current Protection
 - 3.4.17 “P6” Master Control and Driver Communication Error
 - 3.4.18 “P7” Driver Module Sensor Error
 - 3.4.19 “P8” Driver Module High Temperature Protection
 - 3.4.20 “PA” AC Current Protection
 - 3.4.21 “Pc” Driver Current Error
 - 3.4.22 “PL” Bus Low-Voltage Protection
 - 3.4.23 “PH” Bus High-Voltage Protection
 - 3.4.24 “PU” Charge Loop Error
 - 3.4.25 “ee” Drive Memory Chip Error
 
 - 3.5 Failures Not Caused by Errors
 
 - 4 Maintenance
 - Appendices
 - 1 Resistance/Temperature Lists of Temperature Sensors
- 1.1 Voltage List of 15 KΩ Temperature Sensors (including ODU temperature sensors)
 - 1.2 Voltage List of 20 KΩ Pipeline Temperature Sensors (including temperature sensors for defroster, IDU and ODU pipes)
 - 1.3 Voltage List of 50 KΩ Discharge Temperature Sensors (including discharge air temperature sensor)
 
 - 2 Temperature/Pressure List of Refrigerant
 - 3 Operation Tools
 
CONTENTS 
1 Product Introduction ...................................................................................................... 3
1.1 Lists of Units .......................................................................................................................... 3 
1.2 Electrical Parameters ............................................................................................................. 5 
2 Control ............................................................................................................................. 6
2.1 Operation Mode ..................................................................................................................... 6 
2.2 Control Mode ......................................................................................................................... 7 
2.3 Functions ............................................................................................................................... 8 
3 Troubleshooting ............................................................................................................ 12
3.1 Wiring Diagrams .................................................................................................................. 12 
3.2 PCB Layout .......................................................................................................................... 15 
3.3 Error Code ........................................................................................................................... 22 
3.4 Troubleshooting ................................................................................................................... 23 
3.5 Failures Not Caused by Errors ............................................................................................. 48 
4 Maintenance .................................................................................................................. 50
4.1 System Diagram .................................................................................................................. 50 
4.2 Connection Pipe Vacuum Pumping ...................................................................................... 50 
4.3 Refrigerant Charging ............................................................................................................ 52 
4.4 Maintenance of Major Components ...................................................................................... 54 
4.5 Removal of Major Components ............................................................................................ 62 
4.6 Explosive View and Lists of Parts ......................................................................................... 84 
Appendices ...................................................................................................................... 91
1 Resistance/Temperature Lists of Temperature Sensors ........................................... 91
1.1 Voltage List of 15 KΩ Temperature Sensors ......................................................................... 91 
1.2 Voltage List of 20 KΩ Pipeline Temperature Sensors ........................................................... 93 
1.3 Voltage List of 50 KΩ Discharge Temperature Sensors ........................................................ 95 
2 Temperature/Pressure List of Refrigerant .................................................................. 98
3 Operation Tools ............................................................................................................ 98










