mrcool 13seer r410 cond install manual 4web

Unitary Ducted Split AC & HP

Table 5

WIRE RUN LENGTH AWG# INSULATION TYPE

LESS THAN 100’ (30 METERS) 18 Temperature Rating

MORE THAN 100’ (30 METERS) 16 35°C Minimum

A Run 24VAC control wires through cutout with grommet.

B Run 24VAC control wires through wire tie.

C Make 24VAC control wire connections.

NOTE: Wire tie provides low voltage wire strain relief and to maintain separation

of eld low and high voltage circuits

NOTE: For proper voltages, select thermostat wire (control wires)gauge per

table above.

NOTE: Do not bundle any excess 24VAC control wires inside control box.

7.4 Unit High Voltage Connections

A Run HIGH VOLTAGE control wires through cutout with grommet.

B Make HIGH VOLTAGE control wires connections.

C Tighten wire tie to security HIGH VOLTAGE control wiring.

NOTE: Any excess high voltage eld wiring should be trimmed

and secured away from any low voltage eld wiring

NOTE: To facilitate a conduit, a cutout is located in the bottom of the control

box. Connect conduit to the control box using a proper conduit tting.

NOTE: The signal line of the wired controller must be separated from the power

line and the connecting line between the indoor unit and the outdoor unit.

Important Electric Data

Table 6

Model

Compressor

Fan

Motor

Fuse/Breaker

Capacity

Min. Power

Supply Cord

Power Supply Qty. RLA LRA FLA

V/Ph/Hz - A A A A AWG

MAC13018 208/230/1/60 1 7.9 38 1.2 15 AWG16

MAC13024 208/230/1/60 1 9.8 53 1.2 20 AWG14

MAC13030 208/230/1/60 1 12.6 71 1.2 25 AWG12

MAC13036 208/230/1/60 1 15.08 64 1.7 35 AWG12

MAC13042 208/230/1/60 1 21.5 105 1.7 50 AWG10

MAC13048 208/230/1/60 1 21 115 1.7 45 AWG10

MAC13060 208/230/1/60 1 25 150 2.1 50 AWG8

MHP13018 208/230/1/60 1 7.5 38 0.8 15 AWG16

MHP13024 208/230/1/60 1 9.8 53 1.2 20 AWG14

MHP13030 208/230/1/60 1 12.5 71 0.7 25 AWG12

For more details visit www.MrCool.com