Instructions / Assembly
PROPOSITION 65: This appliance contains fiberglass insulation.
All manufacturer products meet current federal OSHA Guidelines
for safety. California Proposition 65 warnings are required for
certain products, which are not covered by the OSHA standards.
California’s Proposition 65 requires warnings for products sold in
California that contain or produce any of the over 900 listed
chemicals known to the State of California to cause cancer or birth
defects. These include, fiberglass insulation, lead contained in
brass, and combustion products from natural gas.
All “new equipment” shipped for sale in California will have labels
stating that the product contains and/or produces Proposition 65
chemicals. Although we have not changed our processes, having
the same label on all our product facilitates manufacturing and
shipping. We cannot always know “when, or if” products will be
sold in the California market.
You may receive inquiries from customers about chemicals found
in, or produced by, some of our heating and air-conditioning
equipment, or found in natural gas used with some of our
products. Listed below are those chemicals and substances
commonly associated with similar equipment in our industry and
other manufacturers.
• Glass Wool (Fiberglass) Insulation
• Carbon Monoxide (CO)
• Formaldehyde
• Benzene
More details are available at the websites for OSHA (Occupational
Safety and Health Administration), at www.osha.gov and the
State of California’s OEHHA
(Office of Environmental Health Hazard Assessment), at
www.oehha.org. Consumer education is important since the
chemicals and substances on the list are found in our daily lives.
Most consumers are aware that products present safety and
health risks, when improperly used, handled and maintained.
INDOOR UNIT
mrcool.com | Page 3
Make sure the blower motor support is
tight, which is secured by 3-motor mount
bolts. Then check to see if the wheel is
secured to motor shaft before operating
unit.
The unit must be properly and permanently grounded. Failure to
do so could result in electrical shock causing personal injury or
death.