Use and Care Manual

Page 48mrcool.com
Connecting DIYPRO™ Cable to Outdoor Unit
ALL WIRING MUST BE INSTALLED STRICTLY IN
ACCORDANCE WITH THE WIRING DIAGRAM
LOCATED ON THE INSIDE OF THE OUTDOOR
CONDENSER WIRE COVER AS SHOWN IN
FIG. 8.8.
3. Now, pull the end of the DIYPRO™ cable through
the hole of the electrical cover you removed
earlier. Please refer to the images below.
1. Remove the screws from the electrical wiring
cover from the outdoor condenser, as shown in
the image below and Fig. 8.8, and remove it.
2. Remove the retaining nut from the end of the
DIYPRO™ cable that you fed through the wall hole
earlier in the installation, as shown in the image
below.
Cover
Outdoor Unit
Wiring Diagram
is located on
the inside of the
wire cover on
the outdoor unit.
Fig. 8.8
Step 1: Connect DIYPRO™ Cable to Outdoor Unit
4. Now, secure the DIYPRO™ cable to the electrical
cover by pushing the threaded end of the cable
into the hole and reinstalling the retaining nut
previously removed. Please refer to the images
below. If installing a multi-zone system,
continue to do this for each of the DIYPRO™
cables coming from each of the air handlers
installed.