Use and Care Manual

Page 14
Operating Instructions
mrcool.com
Special Features & Functions (continued):
Automated Panel Drop Function:
This unit is equipped with four electric motors which raise and lower the air intake grille, which houses the air
filter. This function allows for easy access to the air intake grille and filter for cleaning or replacement if
necessary. The grille can be lowered to a maximum of 4.9 ft (1.5 m) from the ceiling cassette. Below are
instructions of how to raise and lower the panel while using the remote control. For more detailed
instructions of this operation and cleaning the filter, please refer to the Care & Maintenance section of this
manual.
Panel Drop Operation:
1.) While in stand-by mode, press and hold the MODE and DOWN buttons on the remote
control simultaneously for 3 seconds. This will allow you to enter the panel setting mode.
When this mode is accessed the remote controller will display F2.
2.) While in the panel setting mode use the UP or DOWN buttons to raise or lower the air intake
grille, respectively.
3.) Press any button to exit the panel setting mode.
Turbo
CAUTION
DO NOT allow obstacles to get in the path of the panel while it is being raised or lowered. If
the panel comes into contact with an obstruction that causes it to raise while it is being
lowered, it will stop. If the panel comes into contact with an obstruction while being raised
and is not fully retracted, it will automatically lower after a period of time and then try to
rise again. If this occurs three times an error code will display and prompt you to correct this
manually. NOTE: The unit will not function until the obstruction is removed and the panel is
fully retracted and seated in the cassette faceplate.