Owners Manual

Quick Connect® Line Set
(refrigerant pipe)
Pat. https://mrcool.com/mrcool-patents/
BEFORE PERFORMING ELECTRICAL WORK, READ THESE REGULATIONS
All wiring must comply with local and national electrical codes.
2. All electrical connections must be made according to the
Electrical Connection Diagram
located on
the panels of both the indoor and outdoor units.
3.
If there is a serious safety issue with the power supply, stop work immediately. Explain your
to the client, and refuse to install the unit until the safety issue is properly resolved.
4.
5.
6.
7. Do not connect another appliance to the same circuit as the unit.
8. Make sure to properly ground the unit.
9.
Do not allow wires to touch or rest against the refrigerant tubing, compressor, or any other moving
part within the unit.
combustible materials.
Page 31 mrcool.com
Refrigerant Piping Connection
1.
10.
11.
Refrigerant Piping
Signal Cable
Drainage Pipe
Outdoor Unit (Exterior / Condenser)
Fig. 6.3
wrap from
bottom to top
to ensure tape
overlap, as it
will shed water
wrap piping upward to the exterior
wall hole
Quick Connect
®
connections
coil then wrap
bundled excess
wrap the Quick Connec
connections with the black
sound deadening pads.