Owners Manual

Page 17 mrcool.com
Indoor Unit Installation
MOUNTING PLATE DIMENSIONS
In order to ensure that you have ample room to
mount the indoor unit, the diagrams to the right
with the following dimensions:
•
Height & Width of mounting plate
•
Height & Width of indoor unit relative to plate
•
Recommended position of wall hole
•
Relative distances between screw/mounting
holes
•
Do not attempt a left rear wall hole.
Correct orientation of Mounting Plate
31.6 in (802 mm)
9.15 in (232 mm)
16.8 in (426 mm)
11.7 in (297 mm)
1.7 in (43 mm)
1.7 in
(43 mm)
1.7 in
(43 mm)
7.55 in (192 mm)
5.05 in (128 mm)
Series 12K Models
8.6 in (219 mm)
21.77 in (553 mm)
11.8 in (300 mm)
1.7 in (43 mm)
0.6 in (15 mm)
0.6 in (15 mm)
2.1 in
(53.5 mm)
1.8 in
(47 mm)
5.9 in (151 mm)
42.5 in (1080 mm)
13.2 in (335 mm)
Series 18K & 24K Models
Outline of indoor unit
when mounted to plate
Series 36K Models
Right rear wall hole
3.5 in (90 mm) Diameter
Outline of indoor unit
when mounted to plate
Outline of indoor unit
when mounted to plate
Right rear wall hole
3.5 in (90 mm) Diameter
Right rear wall hole
3.5 in (90 mm) Diameter
NOTE REGARDING WALL STUDS
on studs.
marked “US” on the metal bracket.
NOTE: Use a level in order to ensure your
mounting plate is mounted to the wall with
the correct orientation shown above.
Correct Angle to Drill Wall Hole
Keep in mind that the hooks on the mounting
plate are smaller than the holes on the back of
the unit. If you find that there is not enough room
to connect embedded pipes to the indoor unit, it
can be adjusted left or right by 1.25-1.95 in
(30-50 mm), depending on the model.
UNIT IS ADJUSTABLE
(30-50 mm)
(30-50 mm)
Adjustment range of indoor unit to the left or right
Wall
Indoor
Outdoor
Fig. 4.3
0.2 - 0.3in
(5 - 7 mm)
Drill used to
create wall
hole
Wall Hole Sleeve Installation
Fig. 4.4
Fig. 4.5