Remote Control User Manual

How To Use The Buttons
Page 8mrcool.com
S ILE NC E
F P
MODE
FA N
TE MP
ON/OF F
TIME R
ON
TIME R
OFF
1
LE D F OLLOW
ME
TUR BO S E LF
C LE AN
S WING DIRE C T
S LE E P
Dehumidifying Operation
Ensure the unit is properly wired to an appropriate power source and
the power is on.
1. Press the MODE button to select DRY mode.
NOTE
In the DRY mode, you cannot adjust the fan speed. It will be
automatically controlled. You are also not able to control the
temperature setting. In DRY mode the unit will run non-stop and
does not operate based on temperature or humidity.
1
MODE
FA N
TE MP
ON/OF F
TIME R
ON
TIME R
OFF
S ILE NC E
F P
LE D F OLLOW
ME
TURBO S E LF
C LE AN
S WING DIRE C T
S LE E P
Timer Operation
Pressing the TIMER ON button will activate the auto-on time for the
unit. Follow the steps below to set and adjust this function:
1. Press the TIMER ON button. The remote control shows TIMER ON,
the last auto-on setting time, and the signal "H" will be shown on the
LCD display. Now it is ready to reset the auto-on time to START the
operation.
2. Push the TIMER ON button again to set desired auto-on time. Each
time you press the button, the time increases in 30 minute
increments between 0 and 10 hours and by 60 minute increments
between 10 and 24 hours.
3. After setting the TIMER ON, there will be a one second delay before
the remote control transmits the signal to the air conditioner. After
approximately another 2 seconds, the signal "H" will disappear, and
the set temperature will reappear on the LCD display window.
To Set The Auto-On Time