Remote Control User Manual

11
12
14
13
FOLLOW ME Button
Push this button to initiate the Follow Me
feature, the remote will display the actual
temperature at its location. The remote
control will send this signal to the air
conditioner every 3 minutes until
‘Follow Me’ is pressed again. The air
conditioner will cancel the Follow Me feature
automatically if it does not receive the signal
during any 7 minute interval.
Operation of buttons Indicators on LCD
LED Button
Disable / Enable indoor screen display. When
pressed, the indoor screen display is cleared,
press it again to light the display.
Mode display
Information are displayed when
the remote controller is powered
up.
AUTO
HEAT FAN
COOL DRY
5
6
SWING Button
DIRECT Button
Used to change the louver movement and set
the desired up/down air flow direction.
O
The louver changes 6 in angle for each press.
Used to stop or start horizontal louver auto
swing feature.
MODE
FAN
TEMP
SLEEP
ON/OFF
SILENCE
FP
TIMER
ON
TIMER
OFF
1
2
4
3
8
9
7
5
6
10
12
11
13
14
SWING DIRECT
LED FOLLOW
ME
TURBO SELF
CLEAN
TIMER OFF Button
10
Press this button to initiate the auto-off time
sequence. Each press will increase the auto
-timed setting in 30 minutes increments.
When the setting time displays 10.0, each
press will increase the auto-timed setting
60 minutes increments. To cancel the auto-
timed program, simply adjust the auto-off
time to 0.0
For more details visit www.MrCool.com For more details visit www.MrCool.com
Fan speed indication
Displayed when data transmitted.
Displayed when remote controller is ON.
Battery display(low battery detection)
Low speed
Medium speed
High speed
Auto fan speed
Note:
All indicators shown in the figure are for the purpose
of clear presentation. But during the actual operation
only the relative functional signs are shown on the
display window.
Displayed when TIMER ON time is set.
Displayed in Sleep Mode operation.
Indicated that the air conditioner is
operating in Follow me mode
Displayed when TIMER OFF time is set.
Show set temperature or room
temperature, or time under TIMER
setting.