How to Guide

1 2

4. Snap the air handler onto the wall bracket.

STEP 3 - continued

STEP 4 - outside

STEP 4 - continued

1. Place outside condenser unit ﬁrmly on the

ground or attach it to a secure metal wall bracket

or pad. Drain pipe is not required and can be

installed as necessary only if elevated.

2. Remove the plastic seals from the indoor

handler refrigerant lines.

3. Carefully unroll the amount of Quick Connect®

line set needed to connect the indoor handler

ﬁttings and the outside condenser. Leave the coiled

portion stored near the condenser.

4. Align the Quick Connect® refrigerant lines to the

matching indoor handler ﬁttings. Tighten the ﬁrst

few threads by hand.

5. Using open ended wrenches (i.e. crescent or

adjustable): hold the points marked “1” and turn

the nuts only at the points marked “2” (Select the

appropriate wrench according to the dimensions of

the connector).

6. Ensure that the screw connectors do not skew

while working quickly to tighten them.

Ground Installed:

12 in (30 cm)

Bracket Installed:

6 in (15 cm)

clearance between

back and wall

79in (200cm)

in front

12in (30cm)

on left

24in (60cm)

above

24in (60cm)

on right