User Manual

Page 8
Operating Instructions
mrcool.com
Range
fig 2.4
fig 2.3
Deflector Rod
Horizontal Louver
(Horizontal Airow
Grill inside)
Range
fig 2.2
Vertical
Louver
CAUTION
DO NOT Do not put your fingers into the
panel of the blower and suction side. The high
speed fan inside may cause injury.
DO NOT operate the unit for long periods of
time with the airflow direction set downward
in cooling or dehumidifying mode. Otherwise,
condensation might occur on the surface of
the vertical louver causing moisture to drop on
to the floor or furnishings .
DO NOT move the vertical louver manually.
Otherwise, the vertical louver will be out of
sync. IF this happens, cease operation, turn
off power to the unit, remove the wireless
module from the front cover, turn off power to
the circuit (at the breaker), wait for a few
seconds and turn power back on at the break-
er, reinstall wireless module and power the
unit back on.
After a quick restart, the vertical louver may
remain static for approximately 10 seconds.
Open angle of the vertical louver should not
be set too small, as it will restrict airflow and
reduce COOLING and HEATING performance.
1.
2.
Adjust Vertical (Up / Down) Air Flow using Vertical Louver
(g2.2):
Perform this function while the unit is in operation. Use
the remote control to adjust the Vertical Louver /
Vertical Air Flow direction. The vertical louver can move
in small increments for each press, or continuously
swing up and down automatically. Please refer to the
“REMOTE CONTROL USER MANUAL” for details.
Adjust Horizontal (Left/ Right) Airow using Horizontal
Louver (g 2.3, g 2.4):
Move the Deflector Rod manually to adjust the air flow
side to side (left / right) as desired.
Airflow Directional Control
·
Adjust the airflow direction properly.
Otherwise, it might cause discomfort or uneven
room temperatures.
· Adjust the vertical louver using the remote.
· Adjust the horizontal louver manually.