Remote Control Manual

Operation Of Buttons
Page 5 mrcool.com
MODE
FA N
TE MP
S LE E P
ON/OF F
S ILE NC E
F P
TIME R
ON
TIME R
OFF
1
2
4
3
5
6
S WING DIR E C T
LE D F OLLOW
ME
TUR BO S E LF
C LE AN
8
9
7
10
12
11
13
14
TIMER OFF Button
Press this button to initiate the auto-off time sequence.
Each press will increase the auto-timed setting in 30
minute increments. When the time setting displays
10.0, each press will increase the auto-timed setting by
60 minute increments. To cancel the auto-timed
program, simply adjust the auto-off time to 0.0
10
SWING Button
This button is used to stop or start the auto-swing feature of
the horizontal louver. This feature is to aid the distribution of
airflow throughout the room.
11
DIRECT Button
Press this button to change the louver movement and set
the desired up/down air flow direction. Each press of the
button changes the angle of the louver in 6° increments.
12
FOLLOW ME Button
Push this button to initiate the FOLLOW ME feature. The
remote control will display the actual temperature at its
location. The remote control will send this signal to the air
conditioner every 3 minutes until FOLLOW ME is pressed
again. The air conditioner will cancel the FOLLOW ME
feature automatically if it does not receive the signal
during any 7 minute interval.
13
LED Button
This button is used to disable/enable indoor screen
display. When pressed, the indoor screen display is
cleared. Press it again to light the display.
14