Technical data

- 36 -
1.1.5 Balance ambient conditions
This parametre has two settings: STABLE and UNSTABLE. Setting on STABLE
mode makes the balance work much faster than on UNSBABLE mode. This
parametre relates to the ambient conditions in which the balance operates. If the
ambient conditions are unstable it is recommended to use UNSTABLE mode.
Normally the parametre is set on: STABLE.
10.5. Printing mode
This function enables setting the printing mode, i.e. button activity
.
A user has the possibility of selecting the following settings:
• <WHEN STAB> the stable measurement result, along with the settings
for parameter < GLP PRINTOUT> are sent to the printer port. Pressing
the button
, when the result is not stable (no sign on
display), the balance software will send the measurement result to the
port after reaching the stable condition of the measurement.
• <ANYONE> every single pressing of
button results in sending
the measurement result to the printer port along with the settings for
parameter <GLP PRINTOUT>. Every measurement result is sent
(stable and unstable). The <?> sign appears at the beginning of the
printing frame when the result is unstable.
This function applies only to non-verified balances.
• <AUTO> - select this option to enable automatic printing of
measurements. If this option has been selected, remember to select
<AUTO PROG > parameter to suit your needs.
Automatic operation proceeds as follows:
 Press
button to zero the balance (marker of stable
measurement
and zero marker are shown on display)
 Place the load, the balance sends the first stable measurement to
the printer port,
 Remove the load from the balance,
 Next measurement is possible when the reading on the display is
lower than the set value of < AUTO PROG. > parameter (next
measurement does not require zero value).