System information

- 9 -
BPS-Y precise scales
A – scale with d=1mg unit
B – scale with d=10mg unit
After installing scale in its
operating place, following should
be set:
1 – pan mandrels
2 – scale pan
3 – pan shield /for d=1mg/
After the elements setting,
additional devices should be
connected and scale should be
connected to power source. Power
socket is located on back side of
scale casing.
APPB-Y precise scales
Before scale installing In its
operating place, all transport
protections should be removed(1),
then scale pan should be set up
(2).
After the elements setting,
additional devices should be
connected and scale should be
connected to power source. Power
socket is located on back side of
scale casing.
3.3. Scale cleaning
Scale is supposed to be cleaned delicately with wet cloth. All elements should be removed
from weighing chamber while cleaning.
CAUTION!!!
Cleaning installed pan can cause scale’s gear damage
3.4. Connecting to mains
Scale can be connected to mains only with original feeder in which it is equipped.
Turn on scale’s supply - power pack slip must be plugged in socket on back of scale’s
casing.