System information

- 83 -
18.13. Density of solids, liquids and air
Density function consists of three problems: density of solids, density
of liquids and air density. Algorithms of liquids and solids are
accessible for each scale, but air density is accessible only for scales
with d=0,1mg and 0,01mg.
Quick access buttons connected with density function. Choose Yes (visible) or No
(invisible) option for each button.
Calibration
ID definition
Tare setting
Solids
Tare calling
Air
Heading print
Liquids
Text foot print
Statistics
Meter clearing xxx Non-standard buttons
Quick access buttons’ use and operating is described In point 18.6. Weighing mode
parameters- buttons.
Other buttons should be used as instructed In point 18.7.
Information connected with checkweighing:
o Additional unit
o tare
o gross
o meter
o temperature
o density
o statistic data /amount, difference, total, standard deviation etc./
o ID codes
o non-standard information
o non-standardowych information defining
For each information YES or No option should be chosen as displaying criteria.
CAUTION:non-standard information defining is described In point 18.8.4.
Use and operating of other buttons connected with DENSITY function is described In
following part of the manual.
Caution:
Detailed description of procedures and dependences ocuring while solids and liquids density
defining is attached in density defining set MANUAL.