Instruction manual

11
4.2. Unpacking
Carefully remove the balance from its packaging, remove the plastic and foil
wrapping and gently. Install the weighing pan, and other elements according to
below schema:
- Take of the tape which
secures the static voltage
spring on one of the rubber
supporters (2),
- Put on the weighing pan (1)
on the rubber supporters (3),
- After putting on all of above
parts, please check if the
weighing pan is firmly located
on the rubber supporters.
- Take of the tape which
secures the static voltage
spring on one of the rubber
supporters (3),
- Put on the weighing pan (2)
on the rubber supporters,
- Put on the glass draught
shield (1), placed on the
surface of upper casing of the
balance,
- After putting on all of above
parts, please check if the
weighing pan is firmly located
on the rubber supporters.