Installation Guide

steam

INSTALLER INFORMATION

__________________________________________________________________

Locating the Control

Determine the desired installation location of the control. The iSteam

controls are designed to be installed inside or outside the steam room

as a matter of personal preference. If the control is installed inside

the steam room:

• Locate the control 4-5 feet above the oor near the bather seating area.

• The control features an integral temperature sensor. Locate the control in a

location representative of the desired steam bathing temperatures. Do not

locate the control above or near the steam head or direct steam emissions.

• Locate the control on a vertical wall.

• The control cable is 30 feet. Insure that the control and steam generator are

located accordingly.

IMPORTANT NOTES:

• If required, contact MrSteam to purchase an optional 60’ iSteam3

control cable part number 104117-60.

• If the control is installed outside the steam room a Remote Temperature

Probe Part Number MSTS must be installed inside the steam room.

Refer to the MSTS installation manual before installing the control.

• Insure MrSteam steam generator is iSteam3 compatible and has

a serial number 1174000 or higher.

Installation with Optional Rough-In Box

A rough-in box is supplied with iSteam3 for new construction. The rough

-in box will allow precise location of the iSteam3 control and provide a

secure and easily identiﬁable place for the cable while the steam room is

being constructed.

STEP 1

Take the rough-in box out of the package. Remove the two

screws (1a ) and place them in the top and bottom wings of the rough-in

box (1b).

STEP 2

Select a KNOCK-OUT (2a) to route the control cable into the box.

STEP 3 Line up the two TABS (3a) on the right side of the box against a

stud. These TABS help locate the box to sit PROUD of the stud (3b).

STEP 4

SCREW (4a) the two supplied screws into the stud.

STEP 5

Route the CONTROL CABLE (5a) through the back of the rough-in

box and clip it under one of the TABS (5b) that previously held the screws.

The two ends of the control cable are the same.

IMPORTANT NOTE: The control cable should be run in a dedicated 1”

conduit to facilitate installation and service.