Installation Sheet
8
AudioSteam dimensions
Figure 3 shows the face-on dimensions of AudioSteam.
Figure 4 shows the side-view dimensions of AudioSteam.
Locating and installing AudioSteam
To prevent water from getting inside the device, AudioSteam should
be mounted on two stable vertical surfaces (e.g., studs) as shown in
Figure 5.
Using screws and washers, firmly attach AudioSteam using the upper
mounting holes, one at a time, on each side of the unit. Repeat the
process for the lower mounting holes (Figure 5).
Figure 3
Figure 4
Figure 5
IMPORTANT NOTES
1. The following materials (not included) are recommended to
install AudioSteam:
• Four #10 screws of appropriate length with round, truss,
or pan head.
• Four washers with 0.5” outer diameter x 0.0625” thick-
ness (12 mm outer diameter x 1.5 mm thickness).
2. To prevent overtemperature shutoff and equipment damage,
do not use foil insulation in front of AudioSteam.
3. Place AudioSteam far from any electrical noise source, such as
variable speed controls and motors, to prevent interference
that will affect audio quality.
4. In the event of an overtemperature condition, AudioSteam
automatically reduces the volume to protect the amplifier from
damage.
5. To prevent overtemperature shutoff, do not locate in an attic
or other location where ambient temperature may reach 140 °F
(60 °C).
A clearance of at least 0.75” (19 mm) is required to ensure free
heat circulation at the back of the unit.
NOTICE
All drawings are for illustrative purposes only.
mr
.
steam
®
INSTALLATION, OPERATION, AND MAINTENANCE AudioSteam
®
2. Installing AudioSteam
INSTALLER
Shock hazard. Do not place the control box in a loca-
tion where it can get wet.
WARNING
!
REFER
pro
pro
TO
g
g
e
ss
f
or
t
ss for t
INSTALLATION,
e
lower mounting holes (
e lower mounting holes
Fi
gure
5Figure 5
)
.
).
OPERATION
pp
AND
MAINTENANCE
A
A
A
A
A
I
I
I
I
I
N
N
N
N
N
T
TT
T
T
MANUAL
MA
EE
MA
MA
PR
O
VIDED
WITH
W
PR
O
D
UC
C
T
T
T
T
T
FOR
e
ast 0.75”
east 0.75”
the back o
the back o
COMPLETE
9 mm
)
is re
q
uire
d
to ensure
9 mm) is required to ensure
the unit
the unit
INSTRUCTIONS
e
e
ee