Installation Sheet

11
Figure 12
Connecting AudioSteam
to the steam generator
To operate the AudioSteam via iSteam3, you must connect the
AudioSteam (Figure 12) to an internal connector in the steam genera-
tor.
1.
Remove the steam generator cover, and remove knockout on
steam generator.
2.
Connect the control cable directly to the steam generator’s circuit
board (A in Figure 13), OR if an additional accessory is installed
in the steam generator, connect the control cable to the supplied
daughterboard (B in Figure 13).
3.
Plug the AudioSteam power cord into a 120V grounded electrical
outlet.
Power cord to
120V grounded
outlet
Control
cable
mr
.
steam
®
INSTALLATION, OPERATION, AND MAINTENANCE AudioSteam
®
All drawings are for illustrative purposes only.
INSTALLER
Figure 13
Control
cable
Control
cable
Daughterboard
Control cable
Knockout
Steam generator
circuit board
Steam generator
circuit board
Steam generator
circuit board
Steam generator
(shown with cover
removed)
A
B
Shock hazard. Shock hazard. Power must be disconnected at the
main electrical supply before removing the steam generator cover.
For information about the steam generator, refer to the installa-
tion, operation, and maintenance manual supplied with the steam
generator (also found at www.mrsteam.com/technical).
WARNING
!
REFER
outl
out
TO
t.t
TO
INSTALLATION,
INSTALLATION,
OPERATION
OPERATION
AN
A
N
D
ND
N
D
B
B
MAINTENANCE
MAINTE
MANUAL
M
A
PR
O
VIDED WITH
P
P
P
P
P
P
P
P
P
P
P
P
P
P
R
R
R
R
R
R
R
R
R
R
O
D
U
C
T
T
T
T
T
T
T
T
T
T
T
T
T
T
F
F
F
F
F
F
F
F
F
O
O
O
O
O
O
O
O
O
O
O
O
O
O
R
CO
MPLETE IN
S
T
R
R
R
R
R
R
R
R
R
R
R
R
R
R
UC
TI
O
N
S