Installation Sheet

mr
.
steam
®
aromasteam Operation and Installation Instructions
______________________________________________________________________________________________
7
Figure 5
Pressure Valve
Injector Hose
Figure 6
Push Button
AromaSteam
Metering Pump
Adjusting the Amount
of Oil Delivery
The AromaSteam system has been factory set to deliver a
suitable amount of aromatic oil into a typical sized steam room. PLEASE CONTACT
THE MRSTEAM TECHNICAL SERVICE DEPARTMENT BEFORE CHANGING THIS SETTING.
Increasing the settings may introduce excessive concentration of oil into the
steam room, resulting in a health hazard.
Contact the MrSteam Technical Service Department at (800) 76-STEAM (East
coast) or (800) 72-STEAM (West coast)
for assistance or additional information.
Only a qualified licensed electrician or factory authorized
personnel may adjsut the factory setting.
WARNING
!
WARNING
!
Operation
ETEMPO/PLUS
1. Press the AROMA button on the eTempo/Plus
control (Aroma will appear in the display).
2 . When the generator is steaming the pump will inject oil into the
steam line at preset time intervals.
3 . If the generator is not steaming, no oil will be pumped.
TEMPO, TEMPO/PLUS AND ETEMPO
1. With the generator on press the demand button once
(the demand button will light up).
2 . When the generator is steaming the pump will inject oil into the
steam line at preset time intervals.
3 . If the generator is not steaming, no oil will be pumped.
Note: After the generator has been turned off the light on the
demand button will remain ON, the pump will be in stand-by mode
waiting for the generator to be turned on again.
Start-up
Initial Priming of the Pump
1. Insure MrSteam scent container is full.
2. Insert the short injector hose onto the tip of the injector
(see Fig. 5).
3. Unscrew the pressure end nut from the pump head and remove the
pressure hose from the pressure valve (see Fig.3).
4. Insert the open end of the injection hose onto the pressure valve
(see Fig. 5).
5. Draw liquid from the injector slowly and evenly. Continue until the
injector is full of liquid.
6. If you have drawn up the injector completely and no liquid is in the
injector, remove the injector hose from the pressure valve.
7. Drain injector. Repeat steps until the injector is filled.
8. Save the oil injector as it will be needed when new oils are used.
Filling the Pressure Hose
1. Insure the AromaSteam System is primed and the scent container
is full.
2 . Locate the Push-button at the rear of the metering pump (see
Fig. 6). Depress this push-button to start metering pump.
3. Continue to depress push-button until the pressure hose is filled
with liquid.
IMPORTANT NOTE: Push button to be used only for initial filling
of the pressure hose, and after new oil bottles are installed.
Aroma button