Installation Guide

mr.steam

Recessed LED Light Installation

__________________________________________________________________________________________________________________________________________

Also, if you look inside the plug, you’ll notice a groove on the light side and a bump/key on the driver side.

Be sure that the bump/key ﬁts nicely into the slot. Screw the connectors together.

It is important to remember that each model light has its own speciﬁc driver and drivers are NOT inter-

changeable between different model lights.

• Tuck the Driver Box through the Hole

Carefully tuck the driver box up through the hole and allow it to sit on the ceiling at or near the light loca-

tion. If your code/jurisdiction requires you to fasten the driver box to a nearby truss, stud, structural com-

ponent, or other approved member using the keyhole slots provided on the back of the driver box.

• Install Your Light Into the Hole

After you’ve veriﬁed that your light cord is connected

to the driver output cord, gently lift upwards on the

retention clips on each side of your light ﬁxture and

carefully push it into your cut-out hole. Once the light

ﬁxture is in the hole, allow the spring-loaded reten-

tion clips to come down, holding the light ﬁrmly in

place against the drywall or ceiling material. The max-

imum ceiling material thickness that these lights are

designed to work in is 1

”

. Apply a bead of silcone

around the perimeter of the light where it meets the

ceiling as required for sealing.

If you ever need to remove the light in order to access

your driver box , simply grab hold of the sides of the

light and gently pull downwards until the light comes

about 1/2” down out of the hole. Before pulling the

light all the way out of the hole, be sure to get a ﬁrm

grip on the retention clips, so you can hold them up-

wards in order to avoid them snapping closed. Then,

pull the light the rest of the way out of the hole and

gently let the retention clips back down.

• Dimming

LEDLITE is dimmable, make sure to use an ELV style (LED) dimmer switch.

This will be reverse phase dimming.

A few popular dimmers that we have thoroughly tested are:

• Eaton DAL06P • Eaton Toggle AL TAL06P1

• Eaton SAL06P • Eaton AAL06

• Lutron Caseta ELV+ (PD-5NE) • Lutron Maestro MAELV-600

• Lutron Skylark SELV-300P • Leviton Vizia VRE06-1LZ

• Devine Slide Dimmer - DE06P • Lutron Diva DVELV-300P

mr.steam

Sussman-Automatic Corp.

www.mrsteam.com hello@mrsteam.com PN 100534 rev 4.19

43-20 34th Street, Long Island City, NY 11101 1 800 76 STEAM I 9410 S. La Cienega Blvd. Inglewood CA 90301 1 800 72 STEAM