Installation Sheet

Water Feed
1. Connect cold water line.
2. Provide a shut off valve in the water supply line upstream
of the steambath generator.
3. Do not overheat inlet solenoid valve with solder connec
-
tions. Overheating will damage parts.
4. Flush inlet water line thoroughly before making connection
to unit.
5. Strainer recommended upstream of feed water connection.
6. For best performance water pressure should be 15 to 20
PSIG. Reduce pressure as required if necessary.
7. Provide anti-water hammer device as
required.
8. As required by local codes, install an
approved backflow preventer.
9. Do not use PEX or PVC tubing.
WATER FEED
For Illustrative purposes only. Consult with qualified designer,
architect or contractor for steamroom construction details.
4
Water Feed Line
(3/8” NPT)
69992_PUR_100431_MrSteam.indd 5 2013-11-15 07:34