SteamLinx Installation Sheet

3
4
5
6
Troubleshooting: Blinking LED
Tech Service Contact
Warranty
Connecting SteamLinx to the Internet
• Insure the mobile device is on the WiFi network.
• Download the SteamLinx App from the Apple
Store or Google Play by following prompts.
Sussman-Automatic Corporation
®
I [e-mail] I www.mrsteam.com
43-20 34th Street, Long Island City, NY 11101 800 76 STEAM
PUR 100518 1.18
CUSTOMER and TECH SUPPORT
Web: Visit mrsteam.com for additional informaton including
product specifications, locating a device, sizing
calculator, technical downloads and other resources.
Call: Mon.– Fri.: 8 am - 7 pm
East Coast: 1.800.767 STEAM (8326)
West Coast: 1.800.727 STEAM (8326)
Worldwide: 1.718.937.4500
To view or download the SteamLinx
warranty and register, go to
blog.mrsteam.com/wr
Troubleshooting: Indicator Lights
LEDs
Yellow Blinking units are in pairing mode.
Red Router not detected: problem with
connections, router configuration
or steam generator circuit board.
Green SteamLinx B: router is detected but
is not connecting to the internet.
The indicator light on SteamLinx A
will not be illuminated.
Blue Units are connected correctly.
Units are out of range or not paired
• Turn breaker off.
• Insure SteamLinx A is connected to the steam generator.
• Use a paperclip or similar blunt end object to press the reset
button (above the LED) on SteamLinx B.
• The LED will flash yellow (it stays in pairing mode until it
is paired or powered off).
• Turn the breaker to the steam generator ON, if the two
transmitters are functioning correctly and within range
the LEDs will turn blue.
• If the Blue, Green or Red LEDs are blinking the units are not pairing
because they are out of range. Using an extension cord for power,
move the SteamLinx B closer to SteamLinx A. Disconnect the
ethernet cable (the router connection is not required for this test).
If the LEDs stop blinking this confirms the units were out of range.
Home Router
Power
Supply
Ethernet
Cable (3’)
3’ Cable
2
Connecting SteamLinx B to the Home Router
• Plug the blue ethernet cable provided,
into an ethernet slot on
the back of the
home router.
• Plug the power
supply into a
120V outlet.