Controls Installation Sheet

steam

Installation & Operating Instructions

______________________________________________________________

NOTE:

The connector is keyed with the at facing

up. The control cable is the same at both ends.

IMPORTANT NOTE:

Be careful not to

strain, staple, pinch or otherwise damage the

control cable. Route cable as required to permit

replacement. Do not route cable inside conduit

together with power lines or close to hot water or

steam piping.

STEP 4

Diagram 3

Firmly connect the other end of the cable to the

control. Turn on power to the steam generator

and test the control to verify correct connections.

Test per the instructions on pages 10-15. With

veriﬁcation of proper control function, proceed to

Step 5.

If the generator is on for more

than a few minutes steam will start coming out

of the steamhead. Insure that steam room is not

occupied.

STEP 5

Diagram 4

Remove and discard peel-off paper to expose

adhesive liner.

DIAGRAM 3

Drawings for Illustrative Purposes Only.

DIAGRAM 4

CAUTION