Operation Manual

The IP camera can detect motion. This function does not work by using an infrared receiver, but by digitally “looking”
at the image through the camera. When there are too much changes in the image, the motion alarm will be activated.
The sensitivity is adjustable. For outdoor cameras, please note that leaves moving in the wind and rain are also
detected as “motion”. In case of an alarm, the camera can send an alert to the PC (if the software is activated), send
an email, or start recording on the SD card (if available).
In the "Receiver email" field, you should enter the email address that needs to receive the alerts. In the "Sender email"
field you should enter a hotmail or gmail address. Enter the corresponding name (including @gmail.com or
@hotmail.com) and password for the fields “SMTP user name” and “SMTP Password”. Note that “ “587” has to be
entered for “SMTP port”. If you click on “Send a test e-mail”, a test e-mail will be sent. If the test e-mail does not arrive,
please also check the Junk e-mail!
5.2.1.7. Alarm settings
• Motion detection: the camera will give an alarm based on motion.
• Alarm sensitivity: You can select the level of sensitivity that triggers the alarm. Choose high for an alarm that
goes off with the slightest movement. Choose low for an alarm that goes off when there is a very clear change
in the image.
• Sound Detection: The camera will give an alarm based on sounds.
• Sound Sensitivity: you can choose the level of sensitivity that triggers the alarm. Choose high for an alarm that
goes off with the softest sounds. Choose low for an alarm that goes off only if there is a clear and loud sound.
• SD card record: when an alarm is detected, images will be recorded on the SD card.
• Alarm pictures: you can choose the number of photos that will be made when the alarm goes off.
5.2.2. System Settings
12