Installation Guide

8
OPERATING INSTRUCTIONS
Timer Button
 .rewop niam s'tinu eht rof nwodtnuoc eht tes ot desu eb dluohs nottub remit ehT
 debrebme ehT .tinu eht NO rewop ot nottub remit eht sserp nac uoy ,FFO derewop si tinu eht fI
will glow at the brightest setting unless a different setting was saved in the memory.
 ,h5 ,h4 ,h3 ,h2 ,h1 ,03 :era hcihw ,sgnittes remit eht hguorht llorcs ot niaga nottub remit eht sserP
6h, 7h, 8h, 9h and OFF. (30 means 30 minutes)
 ni sgnittes eht niatniam lliw dna rewop niam eht FFO nrut lliw ti ,orez sehcaer remit eht nehW
memory.
Memory Function
 .devas eb lliw )remit gnidulcxe( sgnittes noitcnuf lla ,FFO derewop si tinu eht nehW
 etomer eht no ro lenap lortnoc tresni eht no ecno nottub rewop eht gnisserp ,FFO si tinu eht nehW
control will turn the unit ON and "wakeup" the saved function settings.
 tsal eht ta noitcnuf laudividni eht "puekaw" ot nottub noitcnuf yna sserp ,FFO si tinu eht nehW
saved setting. Press the button again to adjust it and press the main power button on the insert or
on the remote control to turn the unit OFF and save the new setting into memory.
 repmet a fI .gnittes erutarepmet devas eht wohs lliw tuodaer DEL eht ,NO derewop si tinu eht nehW
-ature setting was not saved, it will show the flame brightness setting saved in memory. If neither
one has a setting saved to memory, then only the emberbed will glow (as a power light indicator).
 siht nehW .emit yna ta sdnoces 5 rof nottub rewop niam eht nwod dloh ,yromem eht teser oT
happens, the LED readout will blink with four zeros three times.
 .llaw eht morf tinu eht gulpnu ot si yromem eht teser ot yaw rehtonA
To use the remote control,
first remove the plastic tab
by gently pullling.
HEATER OVERRIDE
The power to the heater can be disengaged to prevent the heater from being accidentally or
unintentionally powered on. This feature is primarily added to help prevent children from powering
on the heater when it is not desired.
 .sdnoces 01 rof nottub erutarepmeT eht dloh dna sserp noitcnuf edirrevo retaeh eht egagne oT
locked. If the heater incon is pressed again E3 will appear then fade. The Flame, Downlight and
 To unlock the heater function, press and hold the Temperature button for 10 seconds. The symbol
E3 will display and then go blank while beeping 3 times. The heater function is now engaged.
By pressing the Temperature button again you will be able to adjust the heat temperature to your
desired temperature.
The symbol E3 will display and then go blank while beeping 3 times. The heater function is now
Timer functions will operate normally. Only the heater and blower are disengaged.