Installation Guide
A.
C.
E.
G.
B.
D.
F.
H.
Turn off the water supply. Remove the faucet
with the mounting hardware attached from the
package.
Insert the shank of the faucet body into the hole
of the sink deck. If installing a base plate, insert
the faucet shank through the base plate rst
followed by the base plate gasket , and then
into the holes of the sink deck.
Hand-tighten the lock nut until secure. Then, use
a screwdriver to tighten each screw slightly until
all are secure.
Install the weights onto the hose using two
screws. Position the weights two feet from the
underside of the sink deck. Use a screwdriver to
tighten the screws securely.
Remove all mounting hardware from the shank.
From the underside of the sink or mounting
surface, attach the rubber washer followed by
the metal washer, nally attach the lock nut and
mounting screws onto the shank.
Plug the spray hose into the quick connect at the
base of the copper tube.
Connect 3/8" compression ttings to each hose,
and then to each corresponding water supply
line. Secure each tting with a 1/4 turn of a
wrench.
Faucet Installation
A
C
E
G
D
F
H
B
2
Installation Guide
shank
1
2
Water supply
Connector
sink deck
rubber washer
metal washer
lock-nut