Install Instructions

Air Conditioner Operation & Features
Page 25 mrcool.com
3
Air Directional Louvers
WARNING
CAUTION
To reduce the risk of fire, electric shock,
or personal injury read the IMPORTANT
SAFETY INSTRUCTIONS before operating
this appliance.
Always wait at least 3 minutes when turning
the unit off then back on again. Also do this
when changing from the COOL setting to the
FAN setting and then back to the COOL
setting. This will prevent the compressor
from overheating and possibly tripping the
circuit breaker.
To begin operating the air conditioner,
follow these steps:
1. Plug in the air conditioner into the wall outlet
(be sure to follow the directions for the power
cord operation).
2. Turn the power on to the air conditioner, using
ON/OFF button.
3. Set the thermostat to the highest number
(coldest setting).
4. Select the COOL mode setting.
5. Adjust the louver for comfortable air flow (see
Air Directional Louvers section and illustrations
to the right).
6. Once the room has cooled, adjust the
thermostat to the setting you find most
comfortable.
7. Make sure that the airflow inside and outside
are not obstructed by anything.
The louvers allow you to direct the airflow Up
or Down (on some models) and Left or Right
throughout the room as needed. Use the SWING
button until the desired up/down direction is
obtained. Move the Louver(s) from side to side
until the desired Left or Right direction of airflow
is obtained.
Operating the Unit
Air Direction
Use SWING button for up/down direction
Adjust louvers for left/right direction
Cooling
Operation
Outdoor temp:
Indoor temp:
64°F-109°F
(18°C-43°C)
60°F-90°F
(16°C-32°C)
Operating Temperature Range
CAUTION
The relative humidity of the room should
be less than 80%. If the unit is operated
in an environment with a relative
humidity above 80%, there will be
condensed water on surface of the unit.
NOTE: Performance may be reduced if the
unit is operated outside of these
temperature ranges.