Install Instructions

Page 21
mrcool.com
Installation Instructions
Top view
Extend into Window Track
The factory installed 1/2“ screw
must be re-used to secure the
Anti-Tip Bracket. Failing to use
this screw could damage the
air conditioner.
Top of Unit
Fig. 21
WARNING
The Anti-Tip Brackets must be
extended into the window track
opening. Failure to follow this
warning could result in serious
injury and/or property damage.
Fig. 22
Top view
Anti-Tip Bracket
Installed in Window
Track Opening
Fig. 23
NOTE: Fig. 22 & Fig. 23 below are to show how the Anti-Tip Bracket is to be installed in the
window track. Note: the Side Arm Foam installed in the previous steps is not shown in this
illustration.
D. The Anti-Tip Brackets must be extended into the window track opening (the vertical track your
window slides up and down in) until it stops and sits against the face of the window track. In order to
make this adjustment you must remove the factory-installed 1/2” Phillips head screw from each
bracket. Once the adjustments have been made, secure the brackets in place by reinstalling the
screws you originally removed. Please refer to the images below.