Install Instructions

Page 17
mrcool.com
Installation Instructions
Fig. 9
C. Once the bracket has been adjusted to
desired level, insert the Main Support Pin
through the holes of the Main Support and
Angled Support Arm. Using the numbers on
the Main Support, repeat the adjustment for
the other Angled Support Arm (matching the
hole and number from first support arm).
Please refer to Fig. 9.
D. Check the level again and ensure
the bracket and arms are secure.
After making any necessary
adjustments, insert the Cotter Pins
into the holes of the Main Support
Pins, as shown in Fig. 10.
NOTE: If further adjustment is needed,
use the alternate holes where the Main
Supports attach to the Horizontal Bracket.
Cotter Pin
Fig. 10
Fig. 11
Cover holes with
Bracket Sealing Foam
Cover holes with
Bracket Sealing Foam
E. If necessary, cover the holes on the front of the bracket with the Bracket Sealing Foam, as
shown in Fig. 11.